Checking the CO2 equipment

Aug 03, 2021

For optimal climate control, accurate and reliable measurements are of course very important and maintenance to the CO2 box should be standard on every farm.

First thing would be to check the tubes and the magnetic valves for leaks. If valves are leaking they need to be replaced immediately as they will cause mixed air in the tubes.

All the tubes can get condense inside and block the air flow, also causing mixed air going into the CO2 sensor and sending the wrong value to the climate control computer. You can avoid this by blowing the tubes out regularly with an air compressor to avoid condense to gather inside them. Especially when tubes are not placed correctly and have no filter at the end of the tube this will happen easy.

A good practice on every farm would be to check the reference measument value on your CO2 system daily. That value is the CO2 measured in your outside conditions which is either outside, in the central duct or wherever the outside measurements sensors and CO2 tube are placed. The ppm value depends on where it is placed but should be consistent and seeing inconsistent value there can be a first indication that there is something wrong with your CO2 meter and some maintenance is needed. A good portable, calibrated CO2 meter can be a great help and indicator. You can detect problems before any misreading’s will cause more damage than necessary.

When all the tubes are clean and no leaks are detected the CO2 meter needs to be calibrated using a zero cartridge for the low values and CO2 calibrated gas for the higher values. Ask your supplier for the exact instructions.

Erik de Groot
Global Agriculture Services
This email address is being protected from spambots. You need JavaScript enabled to view it.


Cookies make it easier for us to provide you with our services. With the usage of our services you permit us to use cookies.